Skip to content

LED Connector

Waterproof Strip-to-Strip Connector FAQ

Joins two sealed strips end to end.

Is there a 2 pin waterproof LED strip connector?

Yes, four Waterproof Strip-to-Strip Connector models are 2-pin, each rated 6 A: AE-IP-SC-2PIN-8MM-A for 8 mm COB or SMD strip, AE-IP-SC-2PIN-10MM-A for 10 mm COB or SMD strip, AE-IP-SMD-2PIN-10MM-A for 10 mm SMD strip and AE-IP-SMD-2PIN-12MM-A for 12 mm SMD strip. Choose by the strip's PCB width and type.

Which strips does the waterproof strip-to-strip connector fit?

Silicone-sleeved, extruded and potted strips with 8–12 mm PCBs. The range has 13 models with 2–6 pins, all rated 6 A, covering single-colour 2-pin strip up to 6-pin strip with AE-IP-SMD-6PIN-12MM-A. It joins two sealed strips end to end.

How do you connect LED strip lights after cutting a waterproof strip?

Cut only at a marked cut point, then join the two ends with a waterproof clip connector matched to the PCB width and pin count. A cut waterproof strip must be resealed to keep its rating, because the IP rating belongs to the finished construction, including the joint and seals. The data gives no IP figure for this connector, so confirm the joint's rating with Artcolor.

How much load can a waterproof strip-to-strip joint carry?

Every model is rated 6 A. The joint carries the current of all the strip beyond it, so by I = P / V that is up to 144 W of downstream strip on 24 V. Feeding a long run from both ends or the middle lowers the current at each joint and reduces voltage drop.

More product questions

Another question about this product?

Send us the project details and our team will answer with the datasheet and a sample offer.