Skip to content

SnipX Cuttable LED Strip

AA2835-24V-120-5mm FAQ

Cut at any LED.

Can you cut the AA2835-24V-120-5mm LED strip to any length?

Nearly — it cuts at every LED, every 8.33 mm, so a run comes within 8.33 mm of any length you need. Each of its 120 LEDs per metre is a segment of its own on 24 V. Cut only at the marked cut points; a cut anywhere else leaves that LED dark.

How do you connect the AA2835-24V-120-5mm after cutting it?

Join it with a solderless clip connector made for a 5 mm board and the strip's pin count, or solder leads to the copper pads. Cut straight across the middle of the pads so each side keeps half a pad, check the polarity, + to +, before switching on, and reseal a waterproof version at the join to keep its IP rating.

What is the AA2835-24V-120-5mm cut-to-length strip used for?

Fine detailing in narrow spaces. It is the narrowest SnipX strip, on a 5 mm board at 9.6 W/m, and gives 858 lm/m at 2700K, 938 lm/m at 3000K and 1000 lm/m at 4000K, with CRI > 90 and SDCM < 3, from 1800K to 6500K. Cutting at every LED lets it fit shelves, niches and small profiles precisely.

What driver and run length suit the AA2835-24V-120-5mm?

A 24 V constant-voltage LED driver, loaded to no more than 80 % of its rated power: the load is 9.6 W/m times the installed length. The catalogue rates the strip at up to 5 m per feed, so longer lines are split and fed in sections. It bends to a 60 mm radius.

More product questions

Another question about this product?

Send us the project details and our team will answer with the datasheet and a sample offer.