Skip to content

LED Connector

Strip-to-Strip Connector FAQ

Joins two strips end to end, no wire.

How do you join two LED strips without soldering?

With a solderless clip connector such as Artcolor's Strip-to-Strip Connector, which joins two strips end to end with no wire. There are 20 models for 5–12 mm PCB widths with 2–6 pins, in the mini IP20 range for COB and SMD strips. Cut each strip only at a marked cut point, then clip both ends into the connector.

Which strip-to-strip LED connector fits my strip?

Match three things: PCB width, pin count and strip type. For example, AE-S-SC-2PIN-8MM-A is for 8 mm 2-pin COB strip, AE-S-SC-2PIN-8MM-A1 for 8 mm 2-pin SMD strip, AE-S-SMD-4PIN-10MM-A for 10 mm 4-pin SMD strip and AE-S-SMD-6PIN-12MM-A for 12 mm 6-pin SMD strip. AE-S-SMD-3PIN-10MM-A1 is for 10 mm 3-pin SMD strip at 168 LED/m.

How much current can a strip-to-strip connector carry?

4 A or 6 A, depending on the model. Most are rated 6 A; AE-S-SC-2PIN-5MM-A1, AE-S-SC-2PIN-8MM-A1, AE-S-COB-5PIN-12MM-A and AE-S-COB-6PIN-12MM-A are rated 4 A. The joint carries the current of all the strip beyond it, so by I = P / V a 6 A joint on 24 V carries up to 144 W of downstream strip.

Can the Strip-to-Strip Connector be used outdoors or on waterproof strip?

No, it is a mini clip connector rated IP20, for bare strips indoors. For silicone-sleeved, extruded or potted 8–12 mm strips, use the Waterproof Strip-to-Strip Connector, which has 13 models with 2–6 pins at 6 A. A cut waterproof strip must be resealed to keep its rating.

More product questions

Another question about this product?

Send us the project details and our team will answer with the datasheet and a sample offer.