Skip to content

CUPOWER Constant Voltage Driver

CUPOWER Constant Voltage ON/OFF CU Series FAQ

48 V constant-voltage on/off drivers, 96–160 W, for built-in or independent mounting.

What is an LED driver, and what does the CUPOWER ON/OFF CU series do?

An LED driver converts mains power into the low-voltage DC an LED strip runs on. The CUPOWER ON/OFF CU series takes 220–240 VAC or 220–240 VDC and gives a constant 48 V output, in 96 W, 120 W and 160 W models. It is rated IP20 and suits built-in or independent mounting.

Is the ON/OFF CU series a constant voltage LED driver for 48 V strips?

Yes. It holds its output at 48 V and the strip draws the current its load needs, by I = P / V. Use it only with strips rated for 48 V input. At the same power a 48 V strip draws half the current of a 24 V strip, so voltage drop is lower and a single feed reaches further than at 24 V.

How much 48 V LED strip can each ON/OFF CU driver run?

Size it so the strip load stays at or below about 80 % of the rating. That is about 76.8 W on the CU-COM-96-48-220...240-OF-FS (0–2 A), 96 W on the CU-COM-120-48-220...240-OF-FS (0–2.5 A) and 128 W on the CU-COM-160-48-220...240-OF-FS (0–3.33 A). Work out the load from the strip's watts per metre times its connected length.

Can the CUPOWER ON/OFF CU series dim an LED strip?

No, it is non-dimmable and suits switched circuits only. For dimming in the CUPOWER range, the DT6 CU series dims 24 V strips over DALI-2 or push dimming and the 5CH CS driver dims over Casambi. For a dimmable 48 V driver, the MEAN WELL PWM series includes 48 V models from 40 W to 200 W.

More product questions

Another question about this product?

Send us the project details and our team will answer with the datasheet and a sample offer.