What is the ABCOBSPI-24V-720-10mm addressable RGB COB pixel strip?
It is a 24 V DC pixel tape that lights as a dotless COB line and changes colour segment by segment. Built-in driver ICs on the 10 mm PCB take data from an SPI pixel controller, so one strip can run chases, gradients and running effects. It carries COB RGB chips at 720 chips/m with a 180° beam, product code ABCOBSPI2472010S15.
Is the ABCOBSPI-24V-720-10mm sold as a 5 m addressable RGB COB strip kit?
Its reel length is 5 m. The strip also needs an SPI pixel controller that supports its IC and a 24 V DC power supply; the product data does not list these as part of the reel, so confirm with Artcolor what is supplied with an order. Power depends on the configuration and is confirmed in the quotation; size the supply so the load stays at or below 80 % of its rating.
How long is one pixel on the ABCOBSPI-24V-720-10mm?
It depends on the IC type and segment length, which are confirmed with the order. A pixel is the smallest part of the strip that can be controlled on its own, and one control IC can drive several chips, so a pixel is a segment rather than a single chip. Build the lighting content on the confirmed segment length, not on the 720 chips/m pitch, and cut only at the marked cut points.
How do you wire and connect the ABCOBSPI-24V-720-10mm pixel strip?
With 3 wires: V+, DATA and GND. Data runs one way, marked by arrows on the PCB, so the controller connects at the input end of each run. The SPI pixel controller must support the exact IC on the strip and send the right channel order. Sections join with the AE-S-COB-3PIN-10MM-B / -C clip connectors, and the strip is made as IP20, IP54, IP65, IP67 or IP68.
Another question about this product?
Send us the project details and our team will answer with the datasheet and a sample offer.