Skip to content
All posts

2 min readBy Artcolor

LED strip connectors: how solderless clip connectors work

An LED strip connector joins strips, leads and wire without soldering. How clip connectors work, why they are not universal, and how to choose the right one.

Two clear clip connectors on COB LED strip, one joining two strips and one connecting a strip to red and black wire

An LED strip connector joins an LED strip to another strip, to a lead or to wire without soldering. A solderless clip connector has metal contacts that press onto the strip's copper pads when the clip is closed, so joints and corners can be made on site.

How a clip connector works

  1. Cut the strip only at a marked cut point.
  2. Slide the strip into the connector, copper pads towards the contacts, until it stops.
  3. Close the clip. The contacts press onto the pads and hold the strip in place.
  4. Check the polarity, + to +, before switching on.

Are LED strip connectors universal?

No. A connector has to match the strip it clips onto:

  • PCB width: the width of the strip's board, such as 5, 8, 10 or 12 mm. A connector made for one width won't hold another.
  • Number of pins: one for each copper pad. Single-colour strips usually have 2 pads and RGB strips 4; others have up to 6.
  • Strip type: COB and SMD strips of the same width can need different connectors.
  • Sealing: a silicone-sleeved, extruded or potted strip needs a waterproof connector made for it. An IP20 clip won't seal it.

Check the current

Every connector has a current rating. The connector at the power feed carries the current for the whole run beyond it: a 72 W run on 24 V draws 3 A. Keep that below the connector's rating.

Connector types

Connector What it does
Strip to strip Joins two strips end to end, no wire
Strip to lead Connects a strip to a factory-fitted 15 cm lead
Strip–wire–strip Joins two strips through a 15 cm wire, for gaps and corners
Strip to wire Takes the installer's own wire, cut to length on site
T and L corner Joins three strips in a T, or turns a strip through 90°, without a wire
Wire to wire Joins two lengths of 2- or 6-core wire
4-in-1 One connector for strip to strip, strip to wire and wire to wire

Artcolor LED connectors

Our LED strip connectors come in 146 models and three series:

  • Mini clip connectors (IP20) for 5–12 mm COB and SMD strips, 2–6 pins.
  • Waterproof connectors for silicone-sleeved, extruded and potted 8–12 mm strips, 2–6 pins.
  • Flex wall washer connectors for the 17 mm lens strip of our flex wall washer, 2–5 pins.

They are rated 4–6 A depending on the model, and the models with wire use 18–24 AWG. The connector page lists each model's PCB width, pins, strip type and maximum current.

Not sure which one fits?

Send us the strip model and we will match the connector.

  • Guides
  • LED strip
  • Connectors

A new lighting-specification tip every day on LinkedIn.

Follow us on LinkedIn

Planning a project?

Tell us about your space — our team will recommend products or build them for you.

Contact sales